Page 1 of 1
vr4 heads are finally....
Posted: Wed Dec 19, 2007 4:26 pm
by DCIV
They are finally off
just from taking the bolt out and scraping around the bolt hole.
Coop
Re: vr4 heads are finally....
Posted: Wed Dec 19, 2007 5:05 pm
by TajMan
Ahhh the heads very nice
oh the memories. I had old 6G72 gaskets sitting on a piece of sheetrock as a "table" for a LONG time. I just used that piece of sheetrock to patch my ceiling in my garage. 6 cylinder outlines very visible, remind me forever now.
Re: vr4 heads are finally....
Posted: Wed Dec 19, 2007 5:44 pm
by My92Stealth
Bout time!
That wasn't so bad, was it? I bet it felt good. Keep at it.
Re: vr4 heads are finally....
Posted: Wed Dec 19, 2007 7:13 pm
by DCIV
I am, they are almost clean. I also droped off the bellhousing to get bored out today.
Coop