BAWC Forums

It blows my mind that that's a $450 option now. Despite all the cost cutting on my truck, they pre-wired it for the keypad. If I want to add it, I need the trim piece (or just cut a hole in mine), and the 15 year old keypad with its short harness. It looks like it's about $20 worth of parts. At least Aaron's cars have a little bit of a premium feel to them. Still not worth anywhere near $450.

Someone just posted a screen shot of the Ford Performance calibrations for the F150 with the 3.5 EcoBoost...

I wish the RS had it. I started to look at adding it, since the ST had it, but then quit looking. Maybe I should start that journey again

Chris GTO TT wrote: ↑Mon Sep 23, 2024 5:01 pm Someone just posted a screen shot of the Ford Performance calibrations for the F150 with the 3.5 EcoBoost...

https://performanceparts.ford.com/part/M-9603-F35

Apparently it's not CA legal

https://www.f150gen14.com/forum/threads ... ess.27797/

Jeff V. wrote: ↑Wed Feb 21, 2024 3:29 pm Can you get DRTY SNW for a license plate?

Ordered. I also got it on the Tahoe plate

Nice. That should be fun.

This is going to be completely silly, but that shouldn't surprise anyone by now.

When you have a minute, can you get these two measurements for me? Doesn't have to be super accurate. Within 1/8 of an inch or so.

So I don't need to bust out the digital calipers?

No. A ruler or tape measure is fine. Just need to get in the ballpark.

That is the HVAC panel I want to put in my truck lol

Something tells me Jeff is going to have it in his truck before you have it in yours

I don't want that one.

I want the better one.

Jeff V. wrote: ↑Wed Oct 16, 2024 4:10 pm This is going to be completely silly, but that shouldn't surprise anyone by now.

When you have a minute, can you get these two measurements for me? Doesn't have to be super accurate. Within 1/8 of an inch or so.

A is a tiny bit over 9 1/4 inches
B is 3 and 7/8 inches

This is awesome.

Coop

There's a fair amount of plastic housing past the edges of the knobs too. I'd guess the whole control assembly is close to 10" wide when you separate it from the bezel. My center stack bezel is only ~9.5" wide. There's issues with the radio controls and airbag status lights too. Probably not worth the hassle.

Thanks for checking for me.

If you have one with the display dials you wanna send my way ...

I'm super glad I put those mudflaps on. I had to park in a muddy field of red dirt and it kept most of the mud off the side steps and off the body. Hosing off the inner fenders and inside of the mud flaps turned the driveway red.

PXL_20241126_234139320.MP by christobal65, on Flickr

That's awesome.